Contact us

S-Q Table

Home › Forums › RORB – general use › S-Q Table

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 27, 2018 at 9:11 PM #1351
    sharif.cqu
    Participant

    Hi,
    I am a new user of RORBWin. I am planning to design a dam for a project. I will appreciate if anyone can answer my below two questions. 1) how can I prepare S-Q Table? 2) how can I use a pump to spill water from dam

    Thanks a lot in advance for a prompt response.

    Cheers,
    Sharif

    October 1, 2018 at 10:02 AM #1352
    DavidStephens
    Moderator

    Hi Sharif

    Thanks for your query. There are several ways to set up a special storage in RORB. Typically, this is best done using an SQ table determined externally using a simple hydraulic calculation or a hydraulic model such as HEC-RAS. Alternatively, you can use the weir/pipe formulation within RORB to simulate the behaviour of various types of outlets.

    In regards to a pump, you would need to incorporate this into an SQ table which was prepared externally.

    Hope this helps.

    June 14, 2022 at 4:25 PM #2555
    roloko3965
    Participant

    watch all spanish daramas here in HD quality http://doramasflix.cl/

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.
Linkedin
Melbourne

Phone: +61 3 9908 2160

Suite 3, 41 Railway Rd
Blackburn VIC 3130

Sydney

Phone: +61 2 8381 6840

PO Box 399
Frenchs Forest NSW 1640

Brisbane

Phone: +61 7 3340 4373

Suite 3 Level 1, 31 Station Rd
Indooroopilly QLD 4068

Copyright © 2024 HARC Services Pty Ltd. All rights reserved.