I don’t think the model has any branches with only dummy reaches. The attached snippet shows a bigger picture of the setup for this interstation area, with the area from my original post highlighted in red. I’m not sure if anything stands out to you?
I can run RORBwin using the individual .stm files with the same .catg file that doesn’t work. There’s no error or temp file created, and the .out file looks great.
Running RORB through the CMD works too, so at the moment the workaround is basically: run RORBwin to generate the .stm files, then run the CMD version again…
As I mentioned earlier, this issue pops up occasionally (not just in this model), but we didn’t realise the “magic fix” until now.
Best Regards,
Yanni
